Installation Method of Metal Saddle Ring Packing

Metal saddle ring packing is an efficient packing material, which is widely used in various reactors and distillation towers in chemical, petroleum, pharmaceutical and other fields. The correct installation method can ensure the stability and effectiveness of the packing in use. Here we introduce the installation method of metal saddle ring packing.

First, we need to clean and inspect the packing layer in the reactor or distillation tower to ensure that its surface is clean and smooth. Then the packing is added to the reactor or distillation tower in turn, taking care that the packing should be smoothly and evenly covered on the supporting plate.

Secondly, when the height of the filler reaches a certain degree, the addition of the filler should be stopped in time, and the filler layer should be uniformly compacted to ensure that the gap between the filler is filled. Use a packing compactor or manual compaction, but do not overcompact the packing, so as not to affect the performance of the packing.

Next, we need to install a layer of partition or network on the surface of the filler layer to prevent excessive friction and collision during the use of the filler, resulting in wear and crushing of the filler. The installation method of the partition or network should ensure that there is no significant gap and movement between it and the packing layer.

Then, we need to install the inlet and outlet at the top and bottom of the reactor or distillation tower respectively, and carry out a tight seal. This can ensure the sealing and safety of the packing layer during use.

In general, the installation method of metal saddle ring packing is relatively simple, but there are many details that need to be paid attention to. The correct installation method can ensure the high efficiency and stability of the packing in use, so as to ensure the normal operation of the reactor or distillation tower.